Extrusion & Post
5 görüntüleme
LDPE Extrusion Coating Neck-in
Sorun Belirtisi
During extrusion coating/lamination, the two edges of the molten film shrink back, and the effective coating width narrows.
Neden Analizi
Elastic shrinkage of the molten film after exiting the die + fast edge cooling; low die temperature, fast haul-off and large melt elasticity all increase neck-in.
Çözüm
①Raise melt temperature; ②reduce haul-off speed; ③optimize air gap distance; ④select low neck-in grades.
Temel Çıkarım
Neck-in = elastic shrinkage; adjust oppositely to lowering temperature and increasing speed.
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!