Extrusion & Post
2 Aufrufe
LDPE Extrusion Coating Neck-in
Problembeschreibung
During extrusion coating/lamination, the two edges of the molten film shrink back, and the effective coating width narrows.
Ursachenanalyse
Elastic shrinkage of the molten film after exiting the die + fast edge cooling; low die temperature, fast haul-off and large melt elasticity all increase neck-in.
Lösung
①Raise melt temperature; ②reduce haul-off speed; ③optimize air gap distance; ④select low neck-in grades.
Wichtigste Erkenntnis
Neck-in = elastic shrinkage; adjust oppositely to lowering temperature and increasing speed.
War das hilfreich?
0 Personen fanden dies hilfreich
Vielen Dank für Ihr Feedback!