Extrusion & Post
7 visualizações
LDPE Extrusion Coating Neck-in
Fenómeno do problema
During extrusion coating/lamination, the two edges of the molten film shrink back, and the effective coating width narrows.
Análise das causas
Elastic shrinkage of the molten film after exiting the die + fast edge cooling; low die temperature, fast haul-off and large melt elasticity all increase neck-in.
Solução
①Raise melt temperature; ②reduce haul-off speed; ③optimize air gap distance; ④select low neck-in grades.
Conclusão principal
Neck-in = elastic shrinkage; adjust oppositely to lowering temperature and increasing speed.
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!