Extrusion & Post
11 görüntüleme
EEA Vacuum Section Material Overflow
Sorun Belirtisi
Material overflows at the vacuum vent section during EEA extrusion, vent hole blocked
Neden Analizi
EEA melt viscosity is low and overflows at the vacuum section; vacuum section temperature is high, viscosity even lower, aggravating overflow; improper vent hole design
Çözüm
1) Lower the vacuum section temperature by 5-10°C to increase viscosity; 2) Add a baffle above the vent hole to prevent overflow; 3) Increase screw speed to accelerate conveying and reduce residence
Temel Çıkarım
Overflow is caused by low melt viscosity; lowering temperature and adding a baffle are key
Bu faydalı oldu mu?
0 kişi bunu faydalı buldu
Geri bildiriminiz için teşekkürler!