Extrusion & Post
9 مشاهدة
Gel Particles on EVOH Extruded Film
ظاهرة المشكلة
EVOH extruded film surface shows 0.1-0.5mm transparent gel particles
تحليل الأسباب
High molecular weight components in EVOH not fully melted during extrusion forming local highly crystalline regions; extrusion temperature too low or mixing insufficient
الحل
1) Increase extrusion temperature by 5-10°C to ensure full melting; 2) Increase screw mixing section length; 3) Inspect raw material to ensure consistent grade; 4) Replace with finer 120 mesh screen to intercept unmelted particles
الخلاصة الأساسية
Gel particles are caused by insufficient melting; increasing temperature and mixing is key
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!