Extrusion & Post
10 visualizações
Gel Particles on EVOH Extruded Film
Fenómeno do problema
EVOH extruded film surface shows 0.1-0.5mm transparent gel particles
Análise das causas
High molecular weight components in EVOH not fully melted during extrusion forming local highly crystalline regions; extrusion temperature too low or mixing insufficient
Solução
1) Increase extrusion temperature by 5-10°C to ensure full melting; 2) Increase screw mixing section length; 3) Inspect raw material to ensure consistent grade; 4) Replace with finer 120 mesh screen to intercept unmelted particles
Conclusão principal
Gel particles are caused by insufficient melting; increasing temperature and mixing is key
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!