Extrusion & Post
7 مشاهدة
Low burst pressure of PET extruded pipes
ظاهرة المشكلة
The burst pressure of PET extruded pipes in pressure testing is lower than design requirements.
تحليل الأسباب
Pipe wall thickness is uneven or has weak points; weld lines (die head spider marks) have insufficient strength; material IV is on the low side; haul-off over-stretches.
الحل
Optimize the die head to reduce weld lines; control wall thickness uniformity; select high-IV raw materials (≥0.80); optimize haul-off speed.
الخلاصة الأساسية
PET pipe burst strength depends on wall thickness uniformity and material intrinsic viscosity.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!