Extrusion & Post
6 visualizaciones
Low burst pressure of PET extruded pipes
Fenómeno del problema
The burst pressure of PET extruded pipes in pressure testing is lower than design requirements.
Análisis de la causa
Pipe wall thickness is uneven or has weak points; weld lines (die head spider marks) have insufficient strength; material IV is on the low side; haul-off over-stretches.
Solución
Optimize the die head to reduce weld lines; control wall thickness uniformity; select high-IV raw materials (≥0.80); optimize haul-off speed.
Conclusión clave
PET pipe burst strength depends on wall thickness uniformity and material intrinsic viscosity.
¿Le ha resultado útil?
0 personas encontraron esto útil
¡Gracias por sus comentarios!