Extrusion & Post
8 visualizações
Low burst pressure of PET extruded pipes
Fenómeno do problema
The burst pressure of PET extruded pipes in pressure testing is lower than design requirements.
Análise das causas
Pipe wall thickness is uneven or has weak points; weld lines (die head spider marks) have insufficient strength; material IV is on the low side; haul-off over-stretches.
Solução
Optimize the die head to reduce weld lines; control wall thickness uniformity; select high-IV raw materials (≥0.80); optimize haul-off speed.
Conclusão principal
PET pipe burst strength depends on wall thickness uniformity and material intrinsic viscosity.
Isto foi útil?
0 pessoas acharam isto útil
Obrigado pelo seu comentário!