Extrusion & Post
7 مشاهدة
PETG extrusion cast film edge thickening
ظاهرة المشكلة
Bead-like thickening appears at the edges of the cast film, with a large thickness difference from the middle.
تحليل الأسباب
After the melt leaves the die, the edge contraction effect (die swell) and surface tension cause thickening, and the cast draw ratio is insufficient.
الحل
Increase the cast draw ratio (air gap adjustment); optimize the die edge compensation design; appropriately lower the melt temperature.
الخلاصة الأساسية
PETG cast film edge thickening is a common phenomenon.
هل كان هذا مفيدًا؟
0 شخص وجدوا هذا مفيدًا
شكرًا لك على ملاحظاتك!